Return to the Blog Home Page

What Causes Water Heater Failure?

Thursday, December 31st, 2020
water heater failure

A water heater failure is a frequent cause of home water damage. At least 75% of water heaters will fail before 12 years of operation. The average cost of damage caused by a ruptured water heater tank exceeds $3,000. For these reasons, most plumbing experts advise preemptive replacement of water heaters when a unit reaches eight to 10 years old.  In addition to the age of the unit, other predictors of potential water heater failure include:

  • Water gets warm but never hot enough
  • Unit makes a rumbling sound when heating
  • Hot water appears rusty or mud-colored
  • Minor leakage beneath the unit

Some causes of water heater failure may be preventable, others are issues you can only stay aware of and be prepared to replace the unit before tank failure and subsequent water damage occurs. Here are some issues that affect the incidence of water heater failure:

  • Internal rust and corrosion. Water heater tanks are subject to internal corrosion that may accelerate eventual water heater failure. Most heaters incorporate sacrificial anode rods to reduce corrosive effects inside the tank. However, anode rods may dissolve before the typical lifespan of the unit has expired and thus need to be replaced. A qualified plumber can check these internal tank rods and replace them if necessary.
  • Sediment accumulation. Dissolved minerals naturally present in hard water commonly accumulate in a layer at the bottom of water heater tanks. This causes the water heater burner to run excessively long cycles to maintain water temperatures, overheating the tank itself and eventually triggering water heater failure and subsequent water damage. Water heaters should be flushed out at least once a year to remove mineral deposits.
  • High water pressure. Residential water pressure should ideally remain in the range of 40 to 60 p.s.i. and never exceed 65 p.s.i. Higher pressure stresses water heater tanks and may make premature water heater failure more likely. A plumber can check household pressure and, if necessary, make necessary adjustments at the pressure reducing valve on the incoming supply line to prevent damage to the water heater, pipes, and other fixtures.

Leaky Water Heater – Repair or Replace?

Tuesday, August 7th, 2018

leaky water heater repairIf you own your house long enough, the odds are you’ll have a leaky water heater. It may happen sooner rather than later, in fact. Forty percent of all new water heaters will be leaking within 9 years and 75% will have failed by the 12-year mark.

While the standard storage tank water heater is not particularly long-lived, not all water heater leaks are an omen that total tank failure—and expensive water damage that accompanies it—are imminent. Here’s how to tell the difference between a needed routine repair and an urgent replacement.

Dribbling T & P Valve

The temperature and pressure relief valve (T & P) is screwed into the upper side or top of the water heater tank. It’s recognizable by its spring-loaded lever for manually testing valve operation. As a safety function in case the water heater overheats, the valve opens to release water and pressure, then closes again. If the unit is not overheating, intermittent dribbling from the T & P usually indicates that mineral deposits are interfering with proper sealing of the valve. In other cases, water may seep out around the threads of the valve. A qualified plumber can diagnose and repair a leaky T & P by installing a new valve. Replacement of the entire water heater is usually not required.

Leaky Drain Valve

The drain valve at the bottom of the unit facilitates draining and flushing the tank. On occasion the valve may also begin dripping even though it is securely closed. The valve resembles a standard faucet and it’s a simple replacement for any plumber.

Leaking Tank

Water dripping from the lower portion or bottom of the tank, often noticed as pooling on the floor around the water heater, is a red flag that warns of impending tank failure. Internal corrosion triggered by layers of mineral deposits in the bottom of the tank causes leakage and, eventually, total rupture of the tank. This is a non-repairable condition and requires replacement of the water heater, ASAP. Costs to remediate home water damage from a major water heater tank rupture average over $3,500.

Water Heater issues? Knowing When To Repair or Replace

Thursday, July 20th, 2017

water heaterChances are, you’ll need to replace a water heater at some point during the ownership of a home. Service life expectancy of residential water heaters runs between 8 and 12 years. In locales where hard water is common, some may fail even sooner. Knowing when you need to replace a water heater, versus when it requires repair or routine maintenance, is important to get as much use out of the unit as possible. Here are some typical scenarios you may encounter.

Issue: Water heater performance is poor and operating costs are rising. Over time, minerals naturally present in the municipal water (chiefly calcium carbonate) form a layer of grainy sediment in the bottom of the water heater tank. This insulates water in the tank from heat of the burner flame. The result is increasingly higher natural gas consumption plus other symptoms like longer recovery times waiting for the tank to heat more water.

Remedy: Have the heater tank flushed once or twice a year to remove mineral deposits before they harden and cannot be removed. This can restore lost energy efficiency and heating performance. It also extends the life of the heater as mineral deposits accelerate tank corrosion.

Issue: Dribbling or oozing from valve on side or top of water heater.

Remedy: This is probably a leaky temperature and pressure relief (TPR) valve. It’s a common replaceable component and you don’t have to buy a new water heater. A qualified plumber can verify the cause and perform a straightforward replacement with a new valve.

Issue: Tank leaking. Frequently this shows up as unexplained pools of water around the heater. You may hear the sizzling sound of water dripping on the hot burner, as well.

Remedy: This usually indicates a corroded, leaky tank. It’s a warning sign that must not be ignored as the tank could rupture at any time and cause extensive water damage. Water heater tanks aren’t repairable so the only safe option is to replace the water heater.

For more about when to replace a water heater to prevent home water damage, contact Rytech, Inc.

Water Heater Leaks Can Lead to Serious Water Damage If Left Undetected

Thursday, January 15th, 2015

Because water heaters are usually located in out-of-the-way places within a home, water heater leaks may go unnoticed. Nevertheless, a leaky water heater can be the source of many problems. Continuous dripping can gradually saturate the sub-flooring or adjacent walls. It’s also an ongoing source of moisture that triggers toxic mold growth. In addition, minor water heater leaks may indicate a corroded tank on the brink of major failure that can cause more widespread water damage.

water heater leakThe usual suspects for water heater leaks include:

  • Cold water and hot water connections – Inlet/outlet pipe connections on top of the heater may be soldered or threaded. If leakage is noted at a threaded connection, tightening it with a pipe wrench may stop it. If you notice leakage from soldered joints, you’ll need a professional plumber to make the fix.
  • Temperature and pressure relief valve – On the side of the tank, a spring-loaded valve opens and closes automatically if water heater temperature and pressure become excessive. Briefly lift the valve handle until water spurts into the drain tube, then let the handle snap shut again. If the valve continues to dribble, you’ll need a plumber.
  • Drain valve leaks – At the bottom of the tank, a faucet-style valve allows the tank to be drained. Make sure the valve is tightly closed. If leakage continues, open the valve and drain a gallon of water into a bucket to flush sediment out of the valve, then close it again. No improvement? Call professional help.
  • Tank failure – Leakage from the bottom of the tank, often heard dripping and sizzling on the burner, is a sign of impending tank failure. Turn off the gas valve and the inlet and outlet water valves and call a plumber.

For damage caused by water heater leaks, contact the professionals at Rytech Inc. today.

Image via Shutterstock.com